Grass Valley Kalypso User Manual V.15.0 - Manual (Page 184)

184 Kalypso — User Manual
Section 3 — System Operation
Deleting a Keyframe
When the edit cursor is on a keyframe, pressing Delete removes that key-
frame from the effect. The Delete button is inactive when the edit cursor is
on the path.
Delete behavior is affected by Constant Duration mode. When Constant
Duration is OFF, the duration of the deleted keyframe is also removed from
the effect (time to the next keyframe). When Constant Duration is ON, the
duration of the previous keyframe is increased by the deleted keyframe’s
duration, so the total duration of the effect is unchanged. After a delete
operation, any keyframes following the deleted keyframe are renumbered
accordingly (
Figure 149 ).
Figure 149. Delete Keyframe
Note that after a Delete with Constant Duration ON the cursor is located on
the path, not on a keyframe. You will need to move the cursor to a keyframe
before you can use
Delete again.
Editing a Keyframe Duration
Showing Keyframe Durations
Pressing the KF Dur button so it is illuminated assigns the keyframe duration
value to the keypad. Once assigned, keyframe durations will be displayed
on the Master E-MEM readout. When the cursor is moved from keyframe
1 2 3 4
0.00 1.00 1.15 3.00
2 3
1.15 3.00
1 2 3
0.00 1.00 2.15
Delete, Const Dur OFF
Edit Cursor On Keyframe
0618_04_135_r0
Effect Duration Shortened
1
0.00
Delete, Const Dur ON
Effect Duration Unchanged
Edit Cursor On Path
Edit Cursor on Keyframe