Grass Valley Kalypso User Manual V.15.0 - Manual (Page 261)

Kalypso — User Manual 261
Router Interface Operation
E-MEM Control of R-MEM
Introduction
R-MEM can be assigned to an E-MEM Enable group, to permit E-MEM
control of R-MEM settings. R-MEM information is learned to the R-MEM
level of an E-MEM register, allowing the selection of specified router
sources when that E-MEM register is recalled. One R-MEM setting is sup-
ported per effect (R-MEM is not keyframeable). Because R-MEM is a level
of E-MEM, there is a one-to-one correspondence between E-MEM and
R-MEM registers. For example, settings in R-MEM register 10 only apply to
E-MEM register 10. This is similar to the relationship between an indi-
vidual M/E E-MEM and the Master E-MEM system. R-MEM information
is added to an E-MEM register using the Learn operation or the Learn Mod
operation.
R-MEM Disk Storage
While R-MEM is organized operationally as a level of an E-MEM register,
R-MEM data is saved to disk separately, as R-MEM registers. This allows
added flexibility. For example, the same E-MEM effect can use different
router source selections or enables, depending on which R-MEM register
has been loaded from disk.
R-MEM Enable Control and Auto Recall
R-MEM also provides an additional level of control. R-MEM has its own set
of enables that control which Kalypso sources (router destinations) are
affected by a recall operation. This aspect of R-MEM is like the enable
groups used for Master E-MEM. The
Auto Recall button on the R-MEM
menu controls R-MEM recalls similar to the control the Auto Recall button on
the Main panel Master E-MEM subpanel exerts over E-MEM recalls. These
are separate functions affecting different control elements, however.
An example of using this is to control which router sources will be changed
without having to learn a new E-MEM register for each variation. Suppose
you learn an R-MEM specifying router sources for several switcher sources,
create an E-MEM effect using those sources, and learn that E-MEM with the
R-MEM Enable button selected. Recalling that E-MEM with the Master
E-MEM
Auto Recall button on will also recall that R-MEM. If the R-MEM
Auto Recall button is also on, the enabled switcher sources will select the
specified router sources. If the R-MEM Auto Recall button is off, only the
switcher sources enabled on the R-MEM menu will be affected by the recall.
Disabling all the switcher sources on the menu makes the E-MEM recall use
the currently selected router sources, with no changes.
E-MEM Prefs Assignment
By default R-MEM is not assigned to any E-MEM Enable group button. You
use the E-MEM Prefs menu (accessed via
Daily Setups / Suite Prefs