Grass Valley Kalypso User Manual V.15.0 - Manual (Page 359)

Kalypso — User Manual 359
Macros
To attach multiple macros to the same button, select another attach mode,
then select the macro register of the additional macro, then touch the button
to which you wish to attach it. Up to three macros (one of each type) can be
attached to the same button.
Attaching a Macro to a Panel Button Using the Menu
1. Go to the Macro Attach menu (touch Macro , Attach ).
2. Select the button you wish to attach a macro to. You can either touch the
physical panel button while
Show Attach mode is active, which will scroll
to and blink that button on the Macro Attach menu, or you can use the
menu to select the panel section and then scroll the Macro Attachments
list to display the desired button.
3. Touch the data pad for that button of the desired type of macro
attachment (
Pre , Replace , Post ). The Macro Attach selection menu will
appear.
4. Touch the menu button for the macro register to be attached. The
selection menu will close and the name of the macro just attached will
be displayed.
Playing an Attached Macro
1. Turn on the attachment playback feature by pressing the Attach Enable
button so it is illuminated. You may also want to press the Show Attach
button so that panel buttons with macros attached can be identified
(they blink low tally).
2. Press the panel button that has the macro attached.
Removing a Macro Attachment
1. Press either the Pre Attach , Repl Attach , or Post Attach button. Any button
can be pressed. All attachments will be removed.
1. Press the Show Attach button so that panel buttons with macros attached
blink low tally.
2. Without selecting a macro register, press the blinking button that has
the attachment you wish to remove. The blinking button will turn off.
3. Press Show Attach to turn off the mode.
Appending to a Macro with the Main Panel
1. Turn on Macro append mode by double pressing the Rec button.