Westermo RedFox Series - Manual (Page 886)

Westermo OS Management Guide
Version 4.17.0-0
On this page you can change the settings for the serial port.
Type Enable/disable the serial port by checking/unchecking
this checkbox.
Type Select serial interface type. Selections only available if
multiple interface types are supported by hardware.
Speed Set serial port data rate.
Data bits Set the number of data bits
Parity Set parity error detection
Stop bits Set the number of stop bits
HW flow control Enable/disable hardware flow control using RTS/CTS
SW flow control Enable/disable software flow control using XON/XOFF
Termination Select serial interface termination for RS422 and
RS485.
886 ➞ 2015 Westermo Teleindustri AB