Westermo RedFox Series - Manual (Page 767)

Westermo OS Management Guide
Version 4.17.0-0
33.3 Managing PPP settings via the CLI
Table 33.3 shows CLI commands related to PPPoE management.
For PPP over serial port (and modems) there are two tables to summarise the
CLI commands:
Table 33.5 presents commands the CLI commands in a generic
way, while Table 33.6 describes CLI commands and default values depending
on the dial mode (”dial in”, ”dial out”, ”dial in,out” and ”no dial” (i.e.,
”null-modem”)).
Command Default Section
Basic and advanced settings for PPPoE
[no] pppoe
Sec. 33.3.1
[no] iface Disabled Sec. 33.3.2
[no] service-name Disabled Sec. 33.3.3
[no] enable Enabled Sec. 33.3.9
[no] identity Disabled Sec. 33.3.10
password
[no] ppp-advanced Sec. 33.3.11
[no] address Auto Sec. 33.3.12
[no] remote-address Auto Sec. 33.3.13
[no] auth-proto Disabled Sec. 33.3.14
[no] aaa-method local-db Disabled Sec. 33.3.15
[no] crypto Disabled Sec. 33.3.16
mppe-128>
[no] proxy-arp Enabled Sec. 33.3.17
[no] demand Disabled Sec. 33.3.18
[no] mru Enabled Sec. 33.3.19
Configure Peer Authentication Lists
aaa
[no] local-db [plain] Sec. 21.3.3
. . .
Table 33.3: CLI setting relevant for PPPoE management. All PPP settings are
available in the ”ppp-advanced” subcontext. The most common PPP settings are
(also) available in the main ”pppoe” context.
➞ 2015 Westermo Teleindustri AB 767