Westermo RedFox Series - Manual (Page 623)

Westermo OS Management Guide
Version 4.17.0-0
Use ”show distance” to show the configured OSPF admin distance value.
Default values 110
27.3.9 Manage area specific settings
Syntax [no] area
Context Router OSPF Configuration context
Usage Enter the OSPF Area Configuration context of the specified AREAID to con-
figure area specific settings, such as area type (regular, stub, nssa), inter-
area route summarisation, etc.
Use ”no area ” to remove specific for a single area, and ”no
area” to remove specific settings for all areas.
Use ”show area []>]” to show a summary of area specific set-
tings. Use ”show area” to show settings for all areas, and ”show area
” to show settings for a specific area. (Also available as ”show”
command within the
OSPF Area Configuration context.)
Default values Disabled (”no area”)
27.3.10 Configure an Area as Stub
Syntax [no] stub [no-summary]
Context OSPF Area Configuration context
Usage Configure an area as a stub area. To create a stub area, all routers in
the area (ABRs as well as internal routers) must declare the area as stub.
To configure the area as a totally stubby area, all ABRs in the area should add
the no-summary parameter to the stub command (”stub no-summary”).
Use ”no stub” to let a stub (or nssa) area become a regular area.
Use ”show stub” to show whether this area is configured as stub or not. If
this is a stub area, it will show whether the ”no-summary” keyword is set or
not, i.e., if it is a totally stubby area or just a stub area.
Default values Disabled (i.e., areas are ”regular” OSPF areas by default)
➞ 2015 Westermo Teleindustri AB 623