Westermo RedFox Series - Manual (Page 54)

Westermo OS Management Guide
Version 4.17.0-0
Context
Port Configuration
end port <...>
monitor end
Context
Port Monitoring
vlan <...> end
General IP
Config. Context
Firewall/NAT
Config. Context
end firewall
Login prompt (console/SSH)
Administrator Execution Context
Global Configuration Context
logout
leave
username & password end/logout
end configure
RMON
Context
end rmon
ip
end
VLAN Configuration
Context
Figure 5.3: Moving between CLI contexts. Only a subset of the available contexts
is shown. Although not shown, the leave and logout commands can be used from
all contexts.
configuration should be saved to the startup-configuration using the ”copy” com-
mand, see also
chapter 7 .
It is also possible to leave the configuration contexts without updating the running-
configuration. The commands to leave a context are listed below. More informa-
tion on these and other general CLI commands can be found in
section 5.4 .
end Confirms configuration changes conducted in this context and
returns to the context immediately above. If issued within the
Global Configuration context, the user returns to the Admin
Exec context and the running-configuration is updated.
leave Confirms configuration changes made and returns to Admin
Exec context. The running-configuration is updated.
Ctrl-Z An alias for leave. Ends your configuration session and returns
to
Admin Exec context.
Continued on next page
54 ➞ 2015 Westermo Teleindustri AB