Westermo RedFox Series - Manual (Page 505)

Westermo OS Management Guide
Version 4.17.0-0
Usage Enable/disable the ICMP ping check. By default the DHCP server will
check that an address is not in use before offering it to a client. In some
rare cases it may be useful to disable this.
Use ”no ping-check” to disable the ping-check mechanism, and ”ping-check”
to enable it.
Run ”show ping-check” to show whether the ping-check mechanism is con-
figured enabled or disabled.
Default values Enabled
22.3.4 DHCP Server Listening UDP port
Syntax [no] server-port
Context DHCP Server Configuration context
Usage Set DHCP Server listening (UDP) port in range 1..65535. By default the
server listens to UDP port 67. Use ”server-port UDPPORT” to set a non-
default UDP port to listen on. See also
section 23.3.5 for the corresponding
DHCP relay agent setting.
Use ”no server-port” to reset to default value (port 67).
Use ”show server-port” to show current server-port settings.
Default values 67
22.3.5 DHCP Server Source/Client UDP port
Syntax [no] client-port
Context DHCP Server Configuration context
Usage Set DHCP Server source (UDP) port in range 1..65535. By default the
server sends DHCP messages with source UDP port 68. Use ”client-port
UDPPORT” to set a non-default UDP port to send from.
Use ”no client-port” to reset to default value (port 68).
Use ”show client-port” to show current client-port settings.
Default values 68
➞ 2015 Westermo Teleindustri AB 505