Westermo RedFox Series - Manual (Page 510)

Westermo OS Management Guide
Version 4.17.0-0
Use ”show netmask” to show the current netmask setting.
Default values The netmask defaults to ”255.255.255.0”, however, a different
netmask can be specified in the ”subnet” command, see section 22.3.12 .
22.3.14 Configure DHCP Server Address Pool
Syntax [no] pool
Context DHCP Server Subnet Configuration context
Usage Specify the IP address pool from which the DHCP server will hand out
leases. The end of the address range can be specified as an IP address
(”IPADDRESS_END”), or as a number (”NUM”). ”NUM” specifies the number of
addresses in the pool, thus ”IPADDRESS_END” is computed as
”PADDRESS_START + NUM − 1”.
Use ”no pool” to disable dynamic address assignment. When disabled,
only static host entries are allowed in the range defined by the subnet itself
and the netmask option.
Use ”show pool” to see the IP addresses in the pool.
Default values A pool based on the configured subnet is automatically setup
when creating a new DHCP subnet.
22.3.15 Configure DHCP Server Lease Time
Syntax [no] lease-time <120-5256000>
Context DHCP Server Subnet Configuration context
Usage Specify the DHCP address lease time (seconds) for addresses handed out
to DHCP clients.
Use ”no lease-time” to reset the lease time setting to its default value.
Use ”show lease-time” to show the current lease-time setting.
Default values 864000 seconds (i.e., 10 days)
510 ➞ 2015 Westermo Teleindustri AB