Westermo RedFox Series - Manual (Page 550)

Westermo OS Management Guide
Version 4.17.0-0
Continued from previous page
Enabled To enable the trigger - check the box, to disable un-
check the box.
Severity Active Severity level when active
Severity Inactive Severity level when inactive
Condition Controls the condition for triggering (High/low)
Sensors The sensor source for this trigger
Threshold Rising The Rising threshold is the higher threshold value for
the sensor. When the current sample value is higher
than this value, and the last sample was lower than
this value, an action is triggered. Valid for none binary
sensors such as temperature and SNR.
Threshold Falling The falling threshold is the lower threshold value for
the sensor. When the current sample value is less than
this value, and the last sample was greater than this
value, an action is triggered. Valid for none binary sen-
sors such as temperature and SNR.
Action Selects the action for the trigger
Port The ports on your switch is grouped as on the actual
hardware, in slots. To get alarms for a a specific port,
check the check-box located underneath the port label.
In the picture above you see ports 1/1, 1/2 and 2/1 are
marked as alarm sources for this link alarm trigger.
550 ➞ 2015 Westermo Teleindustri AB