Westermo RedFox Series - Manual (Page 658)

Westermo OS Management Guide
Version 4.17.0-0
Continued from previous page
Command Default Section
iface
vrrp
[no] mroute-ctrl Disabled Section 30.3.12
Related status commands (MAC FDB, IGMP, etc.)
show fdb
Section 13.4.19
show ip igmp Section 18.3.6
show firewall Section 31.3.13
29.3.1 Enable/disable IP multicast forwarding
Syntax [no] multicast-forwarding
Context IP Configuration context
Usage Enable/disable IP multicast forwarding (multicast routing). Use command
”multicast-forwarding” to enable IP multicast forwarding, given that IP
forwarding (routing) is enabled (”forwarding”, see
section 19.7.4 ).
”no multicast-forwarding” disables IP multicast forwarding.
Use ”show multicast-forwarding” to show whether IP multicast forward-
ing is enabled or disabled.
Default values Disabled (”no multicast-forwarding”)
29.3.2 Configure static multicast routes
Syntax [no] mroute group in
[src ] out
group IPv4 multicast group to route
in Inbound interface for multicast stream
src Optional IPv4 sender address of multicast stream
658 ➞ 2015 Westermo Teleindustri AB