Westermo RedFox Series - Manual (Page 558)

Westermo OS Management Guide
Version 4.17.0-0
24.3.2.4 SNR-Margin Trigger Configuration Example
Note, this setting only applies to units equipped with DSL ports.
Syntax trigger snr-margin
Context Alarm Configuration context
Usage Create a SNR-margin trigger, and enter the Alarm Trigger Configuration
context for this trigger.
Additional settings for SNR-margin triggers are listed below. The only manda-
tory setting is the list of (DSL) ports - no snr-margin alarm events will occur
until (DSL) ports are defined.
❼ Port(s) (mandatory): Define the port or ports this SNR-margin trigger is
associated with.
Note: SNR-margin alarms can only be generated for ports where a con-
nection has been established.
❼ Alarm threshold: As of WeOS v4.17.0 the SNR-margin falling threshold
is set to 3 (dB) by default, and the rising threshold to 6 (dB) by default.
❼ Enable/Disable: By default, the trigger is enabled.
❼ Condition: By default, the alarm condition is set to low. That is, high is
considered normal and low is considered an alarm situation.
❼ Severity: By default, active severity is WARNING and inactive severity
is NOTIFY.
❼ Action: By default, the trigger is mapped to the default action profile
(action 1).
In this example an SNR-margin trigger is created for DSL ports 1/1 and 1/2,
with falling threshold 4 dB and rising threshold 6 dB.
558 ➞ 2015 Westermo Teleindustri AB