Westermo RedFox Series - Manual (Page 776)

Westermo OS Management Guide
Version 4.17.0-0
❼ The aforementioned interface is up at the time when the PPP link is
established.
Use ”show proxy-arp” to view the current setting.
Default values Enabled.
33.3.18 PPP Dial-on-demand
Syntax [no] demand
Context PPP Advanced Configuration context
Usage Dial-on-demand, disconnect after idle timeout in seconds.
Use ”show demand” to check the dial-on-demand setting for this PPP in-
stance.
Default values Disabled (”no demand”)
33.3.19 PPP MRU
Syntax [no] mru
Context PPP Advanced Configuration context
Usage Enable maximum receive unit (MRU) negotiation.
If enabled, MRU parameters will be negotiated with the peer during the PPP
link establishment phase.
The unit will use the PPP interface MTU value (configured or automatic) as
the MRU presented to the peer.
A received MRU parameter from the peer will be acknowledged. The PPP
interface MTU will be set in run-time to the lowest of the MTU value and the
received MRU value.
See chapter 19 for information about MTU.
Use ”no mru” to disable the MRU negotiation. No MRU parameter will be
sent to the peer during the PPP link establishment phase, and any MRU
parameter received from the peer will be rejected.
Use ”show mru” to check the MRU setting for this PPP instance.
776 ➞ 2015 Westermo Teleindustri AB