Westermo RedFox Series - Manual (Page 195)

Westermo OS Management Guide
Version 4.17.0-0
This corresponds to the RMON MIB etherStatsCRCAlignErrors object, except
for the used MAXPKTSIZE (1632 instead of 1518 bytes).
PHY Error Signal Number of received packets generating a receive error signal
from the Ethernet PHY. (Referred to as InMacRcvErr in the CLI port statistics
list)
9.1.5 Outbound Byte Counters
A single outbound byte/octet counter, Outbound Bytes, is provided. It repre-
sents the sum of the length of all Ethernet frames sent on the port. This would
correspond to the Interface MIB ifHCOutOctets object.
The number of Outbound bytes is also used to calculate a rough estimation of
the current sending data rate (Mean Rate, i.e., the number of bytes sent during
a time interval (2 seconds).
9.1.6 Outbound Packets Counters
The following per port counters for outbound Ethernet packets are provided.
Unicast packets The number of packets with a unicast destination MAC address
sent on the port.
This would correspond to the Interface MIB ifOutUcastPkts object.
Multicast packets The number of packets with a group destination MAC ad-
dress (excluding broadcast) sent on the port.
This would correspond to the Interface MIB ifOutMulticastPkts objects, ex-
cept that Pause frames (see below) are not included.
Broadcast packets The number of packets with a broadcast destination MAC
address sent on the port.
This would correspond to the Interface MIB ifOutBroadcastPkts objects.
Pause Frames The number of flow control packets sent.
➞ 2015 Westermo Teleindustri AB 195