Westermo RedFox Series - Manual (Page 728)

Westermo OS Management Guide
Version 4.17.0-0
Continued from previous page
Order The order in which the rules will be applied. When using a
JavaScript enabled browser, it is possible to select one or
more rules and perform an action on multiple rules, see
below. If not using a JavaScript enabled browser, there
will be a set of arrows available to move rules up or down
to change the order of application.
Active A green check-mark means the rule is active, and a dash
means it is inactive.
In Interface The rule will be applied to traffic entering on this inter-
face.
Out Interface The rule will be applied to traffic exiting on this interface.
Source
Address(es) The rule will be applied to traffic originating from a source
with this specific IP-address or an IP-address in the speci-
fied subnet.
Destination
Address(es) The rule will be applied to traffic destined to this specific
IP-address or to an IP-address in the specified subnet.
Destination
Port The rule will be applied to traffic destined to this set of
(UDP/TCP) ports.
Protocol The rule will be applied to traffic using this protocol. Se-
lect the protocol name or enter the protocol number. If
ANY the rule will be applied for all protocol types.
DSCP The DSCP value to be set for packets matching this rule.
Adjust Indicates if the modified DSCP value should be used for
switch internal prioritising and applied to VLAN-priority
on tagged packets. A green check-mark means yes and
a dash means no.
Edit Click this icon to edit a modify rule.
Delete Click this icon to remove a modify rule. You will be asked
to acknowledge the removal before it is actually exe-
cuted.
Selected Rules Selected rules may be modified by selecting the rules
to modify and select the modification action in the drop-
down list and then click the Apply button.
728 ➞ 2015 Westermo Teleindustri AB