Westermo RedFox Series - Manual (Page 51)

Westermo OS Management Guide
Version 4.17.0-0
5.3 Using the CLI
5.3.1 Starting out with the CLI
When first entering the CLI you end up in the Admin Exec context. In the Admin
Exec you can view system status information using various ”show” commands,
upgrade system firmware, etc., as well as other functions, which do not affect the
system configuration.
To be able to modify the switch configuration you should enter the Global Con-
figuration context, by using the ”configure” command as shown below. From
the Global Configuration you are able to configure system parameters such as its
”hostname” or its ”date”.
Example
example:/#> configure
example:/config/#>
As described in section 5.3.2 you can reach other, specific configuration contexts
from the Global Configuration context.
Example
example:/#> configure
example:/config/#> vlan 100
example:/config/vlan-100/#> untagged 1/1,1/2
example:/config/vlan-100/#> end
example:/config/#> end
example:/#>
To get help on what commands are available in the current context, use the
”help” command (see example in
fig. 5.2 ). First the context specific configu-
ration commands are shown, followed by the commands to show the current
configuration settings. At the end, commands available in all contexts are shown
(see also
section 5.4 .).
➞ 2015 Westermo Teleindustri AB 51