Westermo RedFox Series - Manual (Page 657)

Westermo OS Management Guide
Version 4.17.0-0
29.3 Managing Multicast Routing via CLI
The following table shows CLI commands relevant for managing, debugging and
querying static multicast routes in WeOS.
Command Default Section
Configure IP multicast routing
ip
[no] multicast-forwarding Disabled Section 29.3.1
[no] mroute group in Section 29.3.2
[src ] out
Show IP multicast routing status
show ip mroute
Section 29.3.3
There are some additional CLI settings which may be of interest when configuring
IP multicast on your unit. The table below lists the most relevant settings.
Command Default Section
Related settings (IGMP, MAC FDB, VRRP, etc.)
fdb
[no] mac port Section 13.4.3
vlan
[no] igmp Enabled Section 13.4.13
ip
[no] mcast-router-ports Disabled Section 18.3.4
[no] forwarding Enabled Section 19.7.4
icmp
[no] broadcast-ping Enabled Section 19.7.16
firewall
[no] filter [ARGS . . . ] Section 31.3.3
[no] nat [ARGS . . . ] Section 31.3.5
Continued on next page
➞ 2015 Westermo Teleindustri AB 657