Westermo RedFox Series - Manual (Page 264)

Westermo OS Management Guide
Version 4.17.0-0
Usage Enter PoE port configuration context.
Use ”port ” to configure per-port settings for the PoE ports in
the given list, e.g., ”port X2”, or ”port X1-X5,X10”. Use ”port all” to
configure per-port settings for all PoE ports.
Use ”no port ” to reset PoE port settings to their default values
for the given port range.
Default values Not applicable
Error messages None defined yet.
12.3.3 Enable/Disable PoE on a PoE port
Syntax [no] enable
Context PoE Port configuration context.
Usage Enable/disable PoE on this port.
Default values Enabled (”enable”)
Error messages None defined yet.
12.3.4 Set PoE allocation priority
Syntax [no] priority
Context PoE Port configuration context.
Usage Configure PoE allocation priority setting (”priority low” is the lowest
priority, while ”priority critical” is the highest .
”no priority” will reset priority to default (”priority low”).
See section 12.1.2 for information on how to select between ports of the
same configured priority.
Default values Low (”priority low”)
Error messages None defined yet.
264 ➞ 2015 Westermo Teleindustri AB