Westermo RedFox Series - Manual (Page 265)

Westermo OS Management Guide
Version 4.17.0-0
12.3.5 Set PoE Power Limit
Syntax [no] limit <1-30>
Context PoE Port configuration context.
Usage Configure specific PoE Power limit (in Watts) on this port, e.g., ”limit
20” to limit the delivered power to 20 Watts. The max power delivered
is the minimum value of the limit configured for this port, and the power
allocated for class of PoE unit attached (see P
css,oc
in table 12.1 ).
Use ”no limit” to remove port specific power limits (max power based
solely on P
css,oc
).
Default values Disabled (”no limit”)
Error messages None defined yet.
12.3.6 Show PoE Settings
Syntax show poe [port ]
Context Global Configuration context. configuration context. Also available as
❼ ”show [port ]” command in PoE configuration con-
text, and as
❼ ”show” command in PoE Port configuration context
Usage Show global PoE settings and per-port PoE settings. If the ”port
all>” parameter is given (or if run in PoE Port configuration context), only
port specific settings for the given port(s) are listed.
Default values List PoE settings for all ports.
Error messages None defined yet.
12.3.7 Show Enable/Disable PoE Setting
Syntax show enable
Context PoE Port configuration context.
Usage Show whether PoE is enabled (or disabled) on this port.
➞ 2015 Westermo Teleindustri AB 265