Westermo RedFox Series - Manual (Page 618)

Westermo OS Management Guide
Version 4.17.0-0
27.3 Managing OSPF via the CLI
The table below shows OSPF management features available via the CLI.
Command Default Section
Configure General OSPF Settings
router
Sec. 26.3.1
[no] ospf Disabled Sec. 27.3.1
[no] router-id Auto Sec. 27.3.2
[no] network area 0 Sec. 27.3.3
[area ]
[no] neighbor Disabled Sec. 27.3.4
[no] passive-interface Active Sec. 27.3.5
[no] distribute-default [always] Disabled Sec. 27.3.6
[metric-type <1|2>]
[metric <0-16777214>]
[no] redistribute connected Disabled Sec. 27.3.7
[metric-type <1|2>]
[metric <0-16777214>]
[no] redistribute static [metric-type <1|2>] Disabled Sec. 27.3.7
[metric <0-16777214>]
[no] redistribute rip [metric-type <1|2>] Disabled Sec. 27.3.7
[metric <0-16777214>]
[no] distance <1-255> 110 Sec. 27.3.8
[no] area Sec. 27.3.9
[no] stub [no-summary] Disabled Sec. 27.3.10
[no] nssa [no-summary] Disabled Sec. 27.3.11
[no] default-cost <0-16777215> 0 Sec. 27.3.12
[no] range advertise Sec. 27.3.13
[]
Configure Interface Specific OSPF Settings
interface
[no] ospf Sec. 27.3.14
[no] passive [auto] Auto Sec. 27.3.15
[no] cost <1-65535> 10 Sec. 27.3.16
Continued on next page
618 ➞ 2015 Westermo Teleindustri AB