Example – Westermo RedFox Series User Manual

Page 23

Westermo OS Management Guide

Version 4.17.0-0

Example

example:/#> show iface
Press Ctrl-C or Q(uit) to quit viewer, Space for next page, for next line.

Interface Name

Oper

Address/Length

MTU

MAC/PtP Address

----------------

----

------------------

-----

---------------------------

127.0.0.1/8

16436

N/A

vlan1

192.168.2.200/24

1500

00:07:7c:10:de:e1

169.254.145.230/16

------------------------------------------------------------------------------

example:/#>

6. Changing IP address and netmask: To change the switch IP addressing mode

(”static” instead of ”DHCP”), set a static address and netmask, and to skip
secondary addresses, use CLI commands ”configure”, ”iface vlan1”,
”inet static”, ”address ”, ”no address secondary”
and ”end” as shown below. This example is based on the setup in step

and configures the switch with an address (192.168.55.100/24) on the same
IP subnet as the PC.

Example

example:/#> configure
example:/config/#> iface vlan1
example:/config/iface-vlan1/#> inet static
example:/config/iface-vlan1/#> address 192.168.55.100/24
example:/config/iface-vlan1/#> no address secondary
Remove all secondary IP addresses, are you sure (y/N)? y
Removing all secondary IPs!
example:/config/iface-vlan1/#> end
example:/config/#> end
Stopping DHCP Clients ...................................... [ OK ]
Configuration activated.

Remember "copy run start" to save to flash (NVRAM).