Westermo RedFox Series - Manual (Page 242)

Westermo OS Management Guide
Version 4.17.0-0
11.2.1.1 Basic Setup Behavior
As noted above, some settings will be reset when applying the basic setup page.
This is what will happen:
❼ When applying bridged profile:
All but one VLAN is removed and its interface settings are reset.
Details:
– All VLANS are removed and VLAN 1 re-created. As a result of this, all
advanced settings on VLAN 1 and it’s associated interface will be lost.
– All ports are associated untagged to VLAN 1.
– The firewall is removed.
– IP-forwarding (routing) is turned off.
❼ When applying a router profile:
All settings for LAN and WAN and its associated interfaces are reset. Firewall
rules are reset. All existing PPPoE configurations are removed.
Details:
– All VLANS are removed and VLAN 1 (LAN) and VLAN 1006 (WAN) re-
created. As a result of this, all advanced settings on VLAN 1 and VLAN
1006 and their associated interfaces will be lost.
– The DSL port is associated untagged to VLAN 1006 (WAN).
– All remaining ports are associated untagged to VLAN 1 (LAN).
– The firewall is removed and then re-created. This will result in loss of all
current NAT, Port forwarding and Access rules.
– IP-forwarding (routing) is turned on.
In addition for the DHCP and Static modes:
– A NAT-rule for external interface VLAN 1006 (WAN) and internal VLAN 1
(LAN) is added.
– Firewall filtering rules denying inbound UDP and TCP port 53 (DNS) are
added for the external interface VLAN 1006 (WAN).
In addition for the PPPoE mode:
– A PPPoE configuration is added.
242 ➞ 2015 Westermo Teleindustri AB