Westermo RedFox Series - Manual (Page 397)

Westermo OS Management Guide
Version 4.17.0-0
the underlying VLAN interface must also be up. See chapter 33 for more
information on PPP.
❼ GRE interfaces: (only for WeOS Extended) For a GRE interface to get status
up, the GRE interface (and the associated GRE tunnel instance) must be
enabled.
19.2.2 Interface Settings at Factory Default
WeOS products typically have all Ethernet and DSL ports mapped to VLAN 1 by
factory default, and the network interface associated with VLAN 1 is named vlan1.
The exception is Falcon, as described later in this section.hus by factory default,
a WeOS unit has network interfaces vlan1 and lo (logical ”loopback” interface).
The factory default settings for interfaces vlan1 and lo are presented below. Most
of the loopback settings are permanent (non-configurable).
Interface parameters
Factory Default Setting (General)
vlan1 lo
Administrative Mode Enabled Enabled
IP address
Dynamic Static
(DHCP) 127.0.0.1
Netmask (Dynamic) 255.0.0.0
Secondary IP addresses 192.168.2.200 Disabled
Secondary Netmask 255.255.255.0 N/A
MAC address Auto N/A
MTU Auto (1500) 16436
TCP-MSS Disabled Disabled
Admin Distance 1 16
Management Interface Enabled 1 Disabled
The interface administrative distance and management interface concepts are
described in
sections 19.2.6 and 19.2.7 .
As stated earlier, Falcon has a different factory default settings than other WeOS
products. The Ethernet ports are all mapped to VLAN 1 and interface vlan1 as
usual, but the Falcon xDSL port resides on a separate VLAN (VLAN 1006) and
interface (vlan1006). The factory default settings for the associated interfaces
are shown below. Most of the loopback interface (lo) settings are permanent
(non-configurable).
➞ 2015 Westermo Teleindustri AB 397