Westermo RedFox Series - Manual (Page 859)

Westermo OS Management Guide
Version 4.17.0-0
Continued from previous page
Command Default Section
restart > restart 60
[no] compression [adaptive] Adaptive Section 36.3.20
[no] renegotiation-timeout 3600 Section 36.3.21
[no] client-to-client Disabled Section 36.3.22
[no] duplicate-cn Disabled Section 36.3.23
Show SSL VPN Status
show tunnel ssl [ID]
Section 36.3.25
See also (Interface and Firewall Settings)
iface ssl inet
Dynamic (SSL) Sec. 19.6.1
Various Interface settings . . . See Sec. 19.6
ip
[no] firewall Disabled Section 31.3.1
Various Firewall/NAT settings . . . See Sec. 31.3
The table below shows the available CLI commands when configuring the WeOS
unit as SSL client (”[no] server” command set to ”no server”).
Command Default Section
General SSL VPN Settings
tunnel
Section 35.3.1
[no] ssl Section 36.3.1
no server Server Section 36.3.2
[no] enable Enabled Section 36.3.3
[no] description empty Section 36.3.4
[no] type layer3 Section 36.3.5
[no] peer empty Section 36.3.8
Authentication Settings
[no] certificate Empty Section 36.3.9
[no] ca-certificate Empty Section 36.3.10
[no] tls-auth label Empty Section 36.3.11
Continued on next page
➞ 2015 Westermo Teleindustri AB 859