Westermo RedFox Series - Manual (Page 339)

Westermo OS Management Guide
Version 4.17.0-0
15.3.4 Managing FRNT Ring Coupling Uplink Ports
Syntax [no] uplink [PORT]
Context FRNT Ring Coupling Configuration context
Usage Use ”uplink PORT” to define the given port as uplink for this ring cou-
pling node, and enter the Ring Coupling Uplink Configuration context for the
port. A port can be an Ethernet port (
chapter 8 ), a DSL port ( chapter 10 and
chapter 11 ), or a link aggregate ( chapter 17 ).
Up to MAX_RING_COUPLING_UPLINKS ( section 15.4 ) can be created.
Use ”no uplink PORT” to remove the give port as uplink for this ring cou-
pling node, or use ”no uplink” to remove all uplinks for the node.
Use ”show uplink” to list configuration information for all uplinks, and ”show
uplink PORT” to list uplink configuration settings for the given port (also
available as ”show” command within the Ring Coupling Uplink Configura-
tion context for the port.)
Default values Not applicable
15.3.5 Set Ring Coupling Uplink Path-Cost
Syntax [no] path-cost
Context Ring Coupling Uplink Configuration context
Usage Configure uplink path-cost. By default, the path-cost depends on the link
speed and duplex mode (higher speed gives lower cost). It is also possible
to set a cost manually in range 1..2
32 -1 (1..4294967295).
The path-cost is used when electing the active uplink – the link with the
lowest cost will be the active uplink. If the costs of two uplinks are equal,
their uplink priority (
section 15.3.6 ) is considered. For more details, see
section 15.1.3 .
Use ”path-cost auto” to have the uplink’s path-cost depend on its link
speed and duplex mode. Use ”path-cost COST” to set a static path-cost
for the uplink. ”no path-cost” will reset the path cost to the default setting
(auto).
”show path-cost” will show the configured uplink path-cost.
➞ 2015 Westermo Teleindustri AB 339