Westermo RedFox Series - Manual (Page 679)

Westermo OS Management Guide
Version 4.17.0-0
The associated secret can be 4-7 characters. Valid characters are ASCII
characters 33-126, except ’#’ (ASCII 35).
Authentication is not available in VRRP version 3. Authentication will auto-
matically be disabled if version 3 is configured. Use ”no auth” to disable
VRRP message authentication.
Use ”show auth” to show the configured VRRP message authentication set-
ting for this VRRP instance.
Default values Disabled
30.3.10 Configure VRRP Dynamic Priority
Syntax [no] track trigger adjust
Context VRRP Instance Configuration context
Usage Configure dynamic VRRP priority. The VRRP priority will be adjusted by
the given delta value (-255 to 255) when the associated trigger reports
”alarm” status. E.g., ”track trigger 2 adjust -100” will decrease the
VRRP priority by 100 when there is an alarm condition on trigger 2.
When a router is the owner of the VIP, i.e. configured with priority ”255”,
the dynamic priority has no effect.
Use ”no track” to remove (all) track entries defined for this VRRP instance.
(As of WeOS v4.17.0, at most one ”track” entry can be configured.)
Use ”show track” to show the configured VRRP track entries, i.e., the dy-
namic VRRP priority setting.
Default values Disabled
Example In this example, this virtual router’s priority is lowered from 150 to
50, if the router cannot reach the host 192.168.3.11 through the (upstream)
interface vlan2.
➞ 2015 Westermo Teleindustri AB 679