Dell POWEREDGE M1000E - Manual (Page 563)

Fabric OS Message Reference 541
53-1002749-01
HAM-1001
5
HAM Messages
HAM-1001
Message Standby CP is not healthy, device status BAD, Severity = level>.
Message Type FFDC | LOG
Severity CRITICAL
Probable Cause Indicates that a standby control processor (CP) device error is reported by the high availability manager
(HAM) health monitor, with the specified device and severity level. The severity level can be critical,
major, or minor.
The active CP will continue to function normally. Because the standby CP is not healthy, non-disruptive
failover is not possible.
Recommended
Action
Restart the standby CP blade by ejecting the card and reseating it. If the problem persists, replace the
standby CP.
HAM-1002
Message Standby CP is healthy.
Message Type LOG
Severity INFO
Probable Cause Indicates that all standby control processor (CP) devices monitored by the high availability manager
(HAM) health monitor reported no error.
Recommended
Action
No action is required.
HAM-1004
Message Processor rebooted - .
Message Type LOG
Severity INFO
Probable Cause Indicates that the switch has been restarted because of a user action or an error. The switch restart can
be initiated by the firmwareDownload, fastBoot, haFailover, and reboot commands. Some examples
of errors that may initiate this message are hardware errors, software errors, compact flash errors, or
memory errors. The Reboot Reason variable can be one of the following:
• Hafailover
• Reset