Dell POWEREDGE M1000E - Manual (Page 902)

880 Fabric OS Message Reference
53-1002749-01
XTUN-1003
5
XTUN-1003
Message FCIP Tunnel Message Transmission failed:I/T/L/E:Initiator ID>///.
Message Type LOG
Severity ERROR
Probable Cause Indicates a message transmission failure.
Recommended
Action
If there was an unexpected job failure associated with this event, contact your vendor's customer support
for assistance.
XTUN-1004
Message FCIP Tunnel Exchange aborted:I/T/L:/Target ID>/.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the Fibre Channel Protocol (FCP) exchange has been aborted by the initiator.
Recommended
Action
If there was an unexpected job failure associated with this event, contact your vendor's customer support
for assistance.
XTUN-1005
Message
FCP emulation for Tunnel/Initiator/Target/LUN:/Initiator ID>// may not be optimal.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the Fibre Channel Protocol (FCP) emulation is in FastWrite mode and could also be in
Tape Pipelining mode.
Recommended
Action
For disk devices, no action is required. For tape devices, device rediscovery is required.