Dell POWEREDGE M1000E - Manual (Page 327)

Fabric OS Message Reference 305
53-1002749-01
FABR-1004
5
Recommended
Action
Investigate the neighbor switch for problems. Run the errShow command on the neighbor switch to view
the error log for additional messages.
Check for a faulty cable or deteriorated small form-factor pluggable (SFP). Replace the cable or the SFP
if necessary.
Run the portLogDumpPort command on both the receiving and transmitting ports.
Run the fabStatsShow command on both the receiving and transmitting switches.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FABR-1004
Message port: , req iu: 0x
Message Type LOG
Severity WARNING
Probable Cause Indicates that the information unit response was invalid for the specified command sent. The fabric
received an unknown response. This message is rare and usually indicates a problem with the Fabric OS
kernel.
Recommended
Action
If this message is due to a one-time event because of the incoming data, the system will discard the
frame. If it is due to problems with the kernel, the system will recover by performing a failover.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FABR-1005
Message : port : status 0x (failure reason>) xid = 0x.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the application failed to send an async command for the specified port. The message
provides additional details regarding the reason for the failure and the exchange ID of the command. This
can happen if a port is about to go down.
Recommended
Action
No action is required. This message is often transitory.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.