Dell POWEREDGE M1000E - Manual (Page 454)

432 Fabric OS Message Reference
53-1002749-01
FSS-1001
5
FSS Messages
FSS-1001
Message Component () dropping HA data update ().
Message Type LOG
Severity WARNING
Probable Cause Indicates that an application has dropped a high availability (HA) data update.
Recommended
Action
For a dual control processor (CP) system, enable the HA state synchronization using the haSyncStart
command. For non-bladed systems, restart the switch using the reboot command.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
FSS-1002
Message
Component () sending too many concurrent HA data update
transactions ().
Message Type LOG
Severity WARNING
Probable Cause Indicates that an application has sent too many concurrent high availability (HA) data updates.
Recommended
Action
For a dual CP system, enable the HA state synchronization using the haSyncStart command. For
non-bladed systems, restart the switch using the reboot command.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
FSS-1003
Message
Component () misused the update transaction ()
without marking the transaction begining.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the Fabric OS state synchronization (FSS) service has dropped the update because an
application did not set the transaction flag correctly.
Recommended
Action
For a dual CP system, enable the high availability (HA) state synchronization using the haSyncStart
command. For non-bladed systems, restart the switch using the reboot command.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.