Dell POWEREDGE M1000E - Manual (Page 232)

210 Fabric OS Message Reference
53-1002749-01
CDR-1010
5
CDR-1010
Message S,C: Internal monitoring of faults has identified suspect
hardware, blade may need to be reset or replaced: fault1:0x,
fault2:0x thresh2:0x.
Message Type LOG
Severity CRITICAL
Probable Cause Indicates that above-normal errors observed in hardware that may or may not impact the data traffic.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.
CDR-1011
Message S,P(): Link Timeout on internal port
ftx= tov= (>)
vc_no= crd(s)lost= complete_loss:loss>.
Message Type LOG
Severity WARNING
Probable Cause Indicates that one or more credits have been lost on a back-end port, and there is no traffic on that port
for two seconds.
Recommended
Action
Turn on the back-end credit recovery to reset the link and recover the lost credits. If credit recovery has
already been turned on, the link will be reset to recover the credits and no action is required.
CDR-1012
Message S,P(): Port Fault: Hard fault>() fault1= fault2= (0xLLI fault count> 0x 0x).
Message Type LOG
Severity WARNING
Probable Cause Indicates that the specified port has failed. Port initialization will be retried.
Recommended
Action
Replace the SFP transceiver and the cable and then re-enable the port.