Dell POWEREDGE M1000E - Manual (Page 328)

306 Fabric OS Message Reference
53-1002749-01
FABR-1006
5
FABR-1006
Message Node free error, caller: .
Message Type LOG
Severity WARNING
Probable Cause Indicates that the Fabric OS is trying to free or deallocate memory space that has already been
deallocated. This message is rare and usually indicates a problem with the Fabric OS.
Recommended
Action
In case of severe memory corruption, the system may recover by performing an automatic failover.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FABR-1007
Message
IU free error, caller: .
Message Type LOG
Severity WARNING
Probable Cause Indicates that a failure occurred when deallocating an information unit. This message is rare and usually
indicates a problem with the Fabric OS.
Recommended
Action
In case of severe memory corruption, the system may recover by performing an automatic failover.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FABR-1008
Message
.
Message Type LOG
Severity WARNING
Probable Cause Indicates that errors occurred during the request domain ID state; the information unit cannot be
allocated or sent. If this message occurs with FABR-1005, the problem is usually transitory. Otherwise,
this message is rare and usually indicates a problem with the Fabric OS. The error descriptions are as
follows:
• FAB RDI: cannot allocate IU
• FAB RDI: cannot send IU
Recommended
Action
No action is required if the message appears with the FABR-1005 message.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.