Dell POWEREDGE M1000E - Manual (Page 383)

Fabric OS Message Reference 361
53-1002749-01
FCR-1060
5
FCR-1060
Message EX_Port() has an incompatible configuration setting.
Message Type LOG
Severity WARNING
Probable Cause Indicates that virtual channel (VC) Link Init is enabled on the local switch and the remote switch is
negotiating in R_RDY mode. The fabric might not form properly.
Recommended
Action
Check the configuration on the local switch using the portCfgShow command to verify that the VC Link
Init is disabled, if the remote switch is configured in R_RDY mode or only capable of R_RDY mode.
• VC_RDY mode: Virtual channel flow control mode. This is a proprietary protocol.
• R_RDY mode: Receiver-ready flow control mode. This is the Fibre Channel standard protocol,
that uses R_RDY primitive for flow control.
FCR-1061
Message Backbone fabric created on port .
Message Type LOG
Severity INFO
Probable Cause Indicates that a backbone fabric was built on the specified port.
Recommended
Action
No action is required.
FCR-1062
Message Port disabled, system only supports EX/VEX_ports.
Message Type LOG
Severity INFO
Probable Cause Indicates that the maximum number of supported EX_Ports or VEX_Ports was exceeded. To enable the
specified port, disable any other operational port and then re-enable the port.
Recommended
Action
No action is required.