Dell POWEREDGE M1000E - Manual (Page 862)

840 Fabric OS Message Reference
53-1002749-01
SULB-1038
5
SULB-1038
Message Co-CPU has not booted up properly. Skip the firmwaredownload command on the
co-CPU.
Message Type AUDIT | LOG
Class FIRMWARE
Severity WARNING
Probable Cause Indicates that the main CPU cannot access the co-CPU to update the firmware on the co-CPU or run any
other firmware download command on the co-CPU. If the firmwareDownload command is in progress, it
will continue without updating the co-CPU firmware.
Recommended
Action
After the firmware download completes, reboot the CP manually to bring up the co-CPU and run the
firmwareDownload command again. If the problem persists, your switch service provider.
SULB-1039
Message CP has completed relocating the internal firmware image.
Message Type AUDIT | LOG
Class FIRMWARE
Severity INFO
Probable Cause Indicates that the firmware download process has completed normally on the control processor (CP).
Recommended
Action
Run the firmwareShow command to verify the firmware versions.
SULB-1040
Message
An error has occurred during relocation of the internal image on the CP.
Message Type AUDIT | LOG
Class FIRMWARE
Severity WARNING
Probable Cause Indicates that an error has occurred during the relocation of the internal image. The error may be caused
by an inconsistent internal firmware image. It may also be caused by an internal Ethernet failure.
Recommended
Action
Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload
command again if the firmware is not updated.
This will cause the internal image to be relocated again. If the problem persists, contact your switch
service provider.