Dell POWEREDGE M1000E - Manual (Page 858)

836 Fabric OS Message Reference
53-1002749-01
SULB-1023
5
SULB-1023
Message The blade in slot has rebooted during firmwaredownload.
Message Type AUDIT | LOG
Class FIRMWARE
Severity WARNING
Probable Cause Indicates that there may be an error caused by an unexpected disruption of the firmwareDownload
command; for example, powering off and on of the indicated BP blade in the middle of a firmware
download. The error may also be caused by persistent storage hardware failure or by a software error.
Recommended
Action
The firmwareCommit command will be started automatically after the blade boots up to repair the
secondary partition. If at the end of the firmware commit, the blade firmware version is still inconsistent
with the active CP firmware, firmware download will be restarted automatically on the blade. Run the
firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your
switch service provider.
SULB-1024
Message Firmware commit has completed on the blade in slot .
Message Type AUDIT | LOG
Class FIRMWARE
Severity WARNING
Probable Cause Indicates that the firmwareCommit command has completed on the specified blade.
Recommended
Action
Run the firmwareShow command to verify the firmware versions. If the blade firmware is the same as
the active CP firmware, the firmwareDownload command has completed successfully on the blade.
However, if the firmware commit operation has been started to repair the secondary partition, at the end
of the firmware commit, the blade firmware version may still be inconsistent with the active CP firmware.
In this case, firmware download will automatically be restarted on the blade. Run the
firmwareDownloadStatus command to monitor the progress.
SULB-1025
Message The blade in slot will reboot with the new firmware.
Message Type LOG
Severity WARNING
Probable Cause Indicates that new firmware has been downloaded to the specified application processor (AP) blade and
the AP blade will reboot to activate it.