Dell POWEREDGE M1000E - Manual (Page 314)

292 Fabric OS Message Reference
53-1002749-01
EM-1061
5
EM-1061
Message Synchronization halted. Remove all blades of type or upgrade your
standby CP, then reboot or run haSyncStart.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the blade in the system is not supported by the firmware on the standby control processor
(CP).
Recommended
Action
Remove all blades of the specified type or upgrade the standby CP. After an appropriate action is taken,
restart the standby CP or execute the haSyncStart command to enable the high availability (HA) state
synchronization. Until this is done, the system will remain out of synchronization.
EM-1062
Message Blade in slot faulted as it exceeds the maximum support limit of
blades with Blade ID in the chassis.
Message Type LOG
Severity CRITICAL
Probable Cause Indicates that too many blades of a particular type are in the system.
Recommended
Action
Remove the faulted blade.
EM-1063
Message Blade in slot faulted because it exceeds the maximum support limit of
blades with Blade IDs in the chassis.
Message Type LOG
Severity CRITICAL
Probable Cause Indicates that too many blades of a set of particular types are in the system.
Recommended
Action
Remove the faulted blade.