Dell POWEREDGE M1000E - Manual (Page 234)

212 Fabric OS Message Reference
53-1002749-01
CDR-1017
5
CDR-1017
Message Blade in Slot faulted due to unavailable ports in internal Trunk.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the specified blade is faulted due to unavailable ports in internal trunk.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.
CDR-1018
Message Blade in Slot faulted due to Link reset threshold value exceeded.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the specified blade is faulted because the link reset threshold is exceeded.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.
CDR-1019
Message
S,C: HW ASIC Chip TXQ FID parity error threshold reached
type = 0x.
Message Type LOG
Severity WARNING
Probable Cause Indicates that an internal error is observed in the application-specific integrated circuit (ASIC) hardware
that may degrade the data traffic.
Recommended
Action
Restart the system at the next maintenance window.