Dell POWEREDGE M1000E User Manual
Page 851
Fabric OS Message Reference
829
53-1002749-01
SULB-1009
5
"Standby CP failed to boot up."
0x6f
"Standby CP booted up with new firmware."
0x70
"Standby CP failed to boot up with new firmware."
0x71
"Firmware download has completed successfully on standby CP."
0x72
"Firmware download has started on standby CP. It might take up to 10 minutes. "
0x73
"Firmware download has completed successfully on standby CP."
0x74
"Standby CP reboots."
0x75
"Standby CP failed to reboot."
0x76
"Firmware commit has started on standby CP."
0x77
"Firmware commit has completed successfully on standby CP."
0x78
"Standby CP booted up with new firmware."
0x79
"Standby CP failed to boot up with new firmware."
0x7a
"Firmware commit has started on both active and standby CPs."
0x7b
"Firmware commit has completed successfully on both active and standby CPs."
0x7c
"Firmware commit failed on active CP."
0x7d
"The original firmware has been restored successfully on standby CP."
0x7e
"Unable to restore the original firmware on standby CP."
0x7f
"Standby CP reboots."
0x80
"Standby CP failed to reboot."
0x81
"Standby CP booted up with new firmware."
0x82
"Standby CP failed to boot up with new firmware."
0x83
"There was an unexpected reboot during the firmware download operation. The
command is aborted."
0x84
"Standby CP was not responding. The command is aborted."
0x85
"Firmware commit has started on both active and standby CPs. Run the
firmwareDownloadStatus
and
firmwareShow
commands to see the firmware
status."
0x86
"Firmware commit has started on the local CP. Run the
firmwareDownloadStatus
and
firmwareShow
commands to see the firmware status."
0x87
"Firmware commit has started on the remote CP. Run the
firmwareDownloadStatus
and
firmwareShow
commands to see the firmware
status."
0x88
"Run the
firmwareDownloadStatus
and
firmwareShow
commands to see the
firmware status."
0x89
"The
firmwareDownload
command has completed successfully."
0x8a
"The original firmware has been restored successfully."
0x8b
"Remote CP is restoring its secondary partition."
0x8c
"Local CP is restoring its secondary partition."
0x8d
TABLE 7
Status messages and status codes (Continued)
Status message
Status code