Dell POWEREDGE M1000E - Manual (Page 714)

692 Fabric OS Message Reference
53-1002749-01
SEC-1024
5
SEC-1024
Message The security database is too large to fit in flash.
Message Type LOG
Severity INFO
Probable Cause Indicates the size of the security database is too large for the flash memory. The size of the security
database increases with the number of entries in each policy.
Recommended
Action
Reduce the size of the security database by reducing the number of entries within each policy.
SEC-1025
Message Invalid IP address () detected.
Message Type LOG
Severity ERROR
Probable Cause Indicates a corruption occurred during the distribution of the security database. This can occur only when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.
SEC-1026
Message Invalid format or character in switch member .
Message Type LOG
Severity ERROR
Probable Cause Indicates a corruption occurred during the distribution of the security database. This can occur only when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.