Dell POWEREDGE M1000E - Manual (Page 199)

Fabric OS Message Reference 177
53-1002749-01
BL-1041
5
BL-1041
Message Dynamic area mode is enabled on default switch, Faulting the blade w/ ID of blade that has the mini SFP+ that does not support it> in slot as
it does not support this mode.
Message Type LOG
Severity CRITICAL
Probable Cause Indicates that the blade does not support dynamic area mode on the default switch.
Recommended
Action
Turn off the dynamic area mode using the configure command.
BL-1045
Message mini SFP+ (SN: ) is only supported in certain high port
count blades, not blade in slot w/
ID .
Message Type LOG
Severity ERROR
Probable Cause Indicates that mini-SFP+ is supported only by a certain type of blade (FC8-64), but it can be inserted in
other blades.
Recommended
Action
Replace the mini-SFP+ with an SFP or SFP+.
BL-1046
Message error on SFP in Slot which the SFP is inserted>/Port general problems accessing the i2c accessible data> (). Try
reseating or replacing it.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the checksum in an area on the small form-factor pluggable (SFP) transceiver does not
match with the computed value, or there is problem accessing the data.
Recommended
Action
Reseat the SFP transceiver. If problem persists, replace the SFP transceiver.