Dell POWEREDGE M1000E - Manual (Page 323)

Fabric OS Message Reference 301
53-1002749-01
ESW-1004
5
ESW-1004
Message Blade attach failed during recovery, disabling slot = .
Message Type LOG
Severity ERROR
Probable Cause Indicates that the specified blade has failed during failover or recovery.
Recommended
Action
For a bladed switch, execute the slotPowerOff and slotPowerOn commands to power cycle the blade.
For a non-bladed switch, restart or power cycle the switch.
ESW-1005
Message Diag attach failed during recovery, disabling slot = .
Message Type LOG
Severity ERROR
Probable Cause Indicates that the diagnostic blade attach operation has failed during failover or recovery.
Recommended
Action
For a bladed switch, execute the slotPowerOff and slotPowerOn commands to power cycle the blade.
For a non-bladed switch, restart or power cycle the switch.
ESW-1006
Message HA state out of sync: Standby CP (ver = ) does not support
NPIV functionality. (active ver = , NPIV devices = <'1' if
NPIV devices exist; Otherwise '0'>).
Message Type LOG
Severity WARNING
Probable Cause Indicates that the standby control processor (CP) does not support N_Port ID Virtualization (NPIV)
functionality, but the switch has some NPIV devices logged in to the fabric.
Recommended
Action
Load a firmware version on the standby CP that supports NPIV functionality using the
firmwareDownload command.