Dell POWEREDGE M1000E - Manual (Page 380)

358 Fabric OS Message Reference
53-1002749-01
FCR-1048
5
Recommended
Action
No action is required.
FCR-1048
Message On EX port () setting port credits failed.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the indicated credit type was not set. Setting port credits failed.
Recommended
Action
Execute the portEnable command.
If the problem persists, reboot the switch.
If the message persists, collect switch information using the supportSave command, and contact your
switch service provider.
FCR-1049
Message EX_Port () received an ELP command that is not supported.
Message Type LOG
Severity ERROR
Probable Cause Indicates an incoming exchange link parameter (ELP) command that is not supported.
Recommended
Action
Use the portEnable and portDisable to enable or disable the port.
If the problem persists, contact your switch service provider.
FCR-1053
Message Port was disabled, .
Message Type LOG
Severity WARNING
Probable Cause Indicates that the specified port was disabled because of a mismatched configuration parameter.
Recommended
Action
Use the specified disable reason to identify a possible configuration parameter mismatch between the
EX_Port and the switch at the other end of the link.