Dell POWEREDGE M1000E - Manual (Page 155)

Fabric OS Message Reference 133
53-1002749-01
AG-1036
5
AG-1036
Message Port is connected to a non-Brocade fabric with Persistent ALPA
enabled. Check the admin guide for supported configuration.
Message Type AUDIT | LOG
Class CFG
Severity WARNING
Probable Cause Indicates that one of the ports is connected to a non-Brocade fabric.
Recommended
Action
Refer to the Access Gateway Administrator's Guide for the supported configuration.
AG-1037
Message Trunked N_Port () going offline. If switchshow CLI for the connected
fabric switch port displays Persistently disabled: Area has been acquired, then
check cabling: all trunked ports should be in same ASIC Port Group.
Message Type AUDIT | LOG
Class CFG
Severity INFO
Probable Cause Indicates an incorrect cabling.
Recommended
Action
If the switchShow command on the connected fabric switch port displays "Persistently disabled: Area
has been acquired", then check cabling on the Access Gateway. All trunked ports in a single trunk must
belong to the same application-specific integrated circuit (ASIC) port group.
AG-1038
Message Brocade 8000 ports are going to different fabrics, check N_Port ().
Message Type LOG
Severity ERROR
Probable Cause Indicates a misconfiguration.
Recommended
Action
Connect all ports in the port group to the same fabric.