Dell POWEREDGE M1000E - Manual (Page 330)

308 Fabric OS Message Reference
53-1002749-01
FABR-1012
5
FABR-1012
Message : no such type, .
Message Type LOG
Severity WARNING
Probable Cause Indicates that the fabric is not in the appropriate state for the specified process. This message is rare and
usually indicates a problem with the Fabric OS.
Recommended
Action
The fabric daemon will take proper action to recover from the error.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FABR-1013
Message
No Memory: pid= file= line=within the source file>.
Message Type FFDC | LOG
Severity CRITICAL
Probable Cause Indicates that there is not enough memory in the switch for the fabric module to allocate. This message is
rare and usually indicates a problem with the Fabric OS.
Recommended
Action
The system will recover by failing over to the standby CP.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FABR-1014
Message Port Disabled: Insistent Domain ID could not be
obtained. Principal Assigned Domain ID = .
Message Type LOG
Severity ERROR
Probable Cause Indicates that the specified port received a request domain ID (RDI) accept message containing a
principal-switch-assigned domain ID that is different from the insistent domain ID (IDID). Fibre
connectivity (FICON) mode requires an insistent domain ID. If an RDI response has a different domain
ID, then the port is disabled.
Recommended
Action
Run the configShow command to view the fabric.ididmode. A 0 means the IDID mode is disabled; a 1
means it is enabled.
Set the switch to insistent domain ID mode. This mode is set under the configure command or in Web
Tools on the Switch Admin > Configure window.