Allied Telesis AT-S62 - Manual (Page 85)

AT-S62 Management Software Menus Interface User’s Guide
Section I: Basic Operations 85
Selecting a Switch in an Enhanced Stack
Before you perform a procedure on a switch in an enhanced stack, you
should first check to be sure that you are performing it on the correct
switch. If you assigned system names to your switches, this should be
easy. The name of the switch being managed is always displayed at the
top of every management menu.
When you start a local or remote management session on the Master
switch of an enhanced stack, you are by default addressing that particular
switch. The management tasks that you perform affect only the master
switch.
To manage a slave switch or another Master switch in the stack, you need
to select it from the management software.
To select a switch to manage in an enhanced stack, perform the following
procedure:
1. From the Main Menu, type 8 to select Enhanced Stacking.
2. From the Enhanced Stacking menu, type 2 to select Stacking
Services.
Note
The Stacking Services selection is only available on a Master switch.
The Stacking Services menu is shown in Figure 16.
Figure 16. Stacking Services Menu
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Stacking Services
Switch Software Switch
Num MAC Address Name Mode Version Model
-------------------------------------------------------------
1 - Get/Refresh List of Switches
2 - Sort Switches in New Order
3 - Access Switch
4 - Load Image/Bootloader File
5 - Load Configuration File
R - Return to Previous Menu
Enter your selection?