Allied Telesis AT-S62 - Manual (Page 735)

AT-S62 Management Software Menus Interface User’s Guide
Section VII: Management Security 735
Configuring SSL
To configure the SSL protocol, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
2. From the Security and Services menu, type 9 to select Secure Socket
Layer (SSL).
The Secure Socket Layer (SSL) menu is shown in Figure 251.
Figure 251. Secure Socket Layer (SSL) Menu
3. Select 1 - Maximum number of Sessions to increase the number of
sessions.
Enter a value from 1 to 100. The maximum number of sessions is used
to speed up a connection. By increasing the number of sessions, you
increase HTTPS performance. However, increasing the number of
sessions also increases the memory requirements. The default is 50.
4. Select 2 - Session Cache Timeout to increase or decrease the timer
that determines when the session cache times out.
5. Enter a value, in seconds, from 1 to 600. The default is 300 seconds.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Allied Telesyn Ethernet Switch - AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Secure Socket Layer (SSL)
1 - Maximum Number of Sessions......... 50
2 - Session Cache Timeout.............. 300 seconds
R - Return to Previous Menu
Enter your selection?