Allied Telesis AT-S62 - Manual (Page 207)

AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 207
15. If you downloaded a new configuration file and you want to make it the
switch’s active boot file, go to “Setting the Active Boot Configuration
File” on page 179. If you downloaded a CA certificate and need to add
it to the certificate database, refer to “Adding a Certificate to the
Database” on page 722.
Downloading a
File from a Telnet
Management
Session
Review “Guidelines” on page 202 before performing this procedure.
To download a file onto a switch from a Telnet management session using
TFTP, perform the following procedure:
1. Establish a Telnet management session on the switch where you want
to download the file.
2. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
3. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 6 on page 57.
4. For the System Utilities menu, type 2 to select Downloads and
Uploads.
The Downloads and Uploads menu is shown in Figure 51 on page 190.
5. Type 3 to select Download a File.
The following prompt is displayed:
Only TFTP downloads are available for a Telnet access
TFTP Server IP address:
6. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name:
7. Enter the name of the file on the TFTP server to download onto the
switch.
The following prompt is displayed:
Local File Name:
8. Enter a name for the file for when it is stored in the switch’s file system.
The name can be up to 32 alphanumeric characters. Spaces are
allowed, but special characters (e.g., /, \, #, and %) should not be used.
The extension should correspond to its file type. Supported extensions
and file types are listed in Table 3 on page 204.