Allied Telesis AT-S62 - Manual (Page 472)

Chapter 21: SNMPv3
472 Section III: SNMPv3
Displaying SNMPv3 Table Menus
The procedures in this section describe how to display the SNMPv3
Tables. The following procedures are provided:
ˆ “Displaying the Display SNMPv3 User Table Menu” on page 472
ˆ “Displaying the Display SNMPv3 View Table Menu” on page 474
ˆ “Displaying the Display SNMPv3 Access Table Menu” on page 475
ˆ “Displaying the Display SNMPv3 SecurityToGroup Table Menu” on
page 476
ˆ “Displaying the Display SNMPv3 Notify Table Menu” on page 477
ˆ “Displaying the Display SNMPv3 Target Address Table Menu” on
page 478
ˆ “Displaying the Display SNMPv3 Target Parameters Table Menu” on
page 479
ˆ “Displaying the Display SNMPv3 Community Table Menu” on
page 480
Displaying the
Display SNMPv3
User Table Menu
This section describes how to display the Display SNMPv3 User Table
Menu. For information about the SNMPv3 User Table, see “Creating an
SNMPv3 User Table Entry” on page 386.
To display the Display SNMPv3 User Table Menu, perform the following
procedure.
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 17 on page 93.
3. From the SNMP Configuration menu, type 5 to select Configure
SNMPv3 Table.
The Configure SNMP Menu is shown in Figure 133 on page 387.
4. From the Configure SNMP Menu, type 6 to select Display SNMPv3
Table.