Allied Telesis AT-S62 - Manual (Page 440)

Chapter 21: SNMPv3
440 Section III: SNMPv3
The Configure SNMPv3 Target Address Table Menu is shown in
Figure 146 on page 450.
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 SecurityToGroup Table Menu, type N to display
the Next Page and P to display the previous page.
3. To delete an SNMPv3 Target Address Table entry, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Address Name:
4. Enter a Target Address Name.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N): [Yes/No]->
5. Enter Y to delete the SNMPv3 Target Address Table entry or N to save
it.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 Target
Address Table
Entry
This section describes how to modify parameters in an SNMPv3 Target
Address Table entry. See the following procedures:
ˆ “Modifying a Target IP Address” on page 441
ˆ “Modifying the Target Address UDP Port” on page 442
ˆ “Modifying the Target Address Timeout” on page 443
ˆ “Modifying the Target Address Retries” on page 444
ˆ “Modifying the Target Address Tag List” on page 445
ˆ “Modifying the Target Parameters Field” on page 446
ˆ “Modifying the Storage Type” on page 447
Note
You cannot modify the Target Address Name parameter.