Allied Telesis AT-S62 - Manual (Page 523)

AT-S62 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 523
Configuring MSTP Bridge Settings
This section contains the procedure for configuring a bridge’s MSTP
settings.
Note
You cannot configure the MSTP parameters until you have selected
the protocol as the active spanning tree protocol on the switch. For
instructions, refer to “Selecting MSTP as the Active Spanning Tree
Protocol” on page 522.
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 163 on page 493.
2. From the Spanning Tree Menu, type 3 to select Configure Active
Protocol.
The MSTP Menu is shown in Figure 178.
Figure 178. MSTP Menu
Menu selections 1 to 9 are described below. Selections C, M, V, and P
are described in later sections in this chapter.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
MSTP Menu
1 - Force Version .......... MSTP
2 - Hello Time ............. 2/2 (Configured/Actual)
3 - Forwarding Delay ....... 15/15 (Configured/Actual)
4 - Max Age ................ 20/20 (Configured/Actual)
5 - Max Hops ............... 20
6 - Configuration Name .....
7 - Revision Level ......... 0
8 - Bridge Identifier ...... 32768/00:30:84:00:00:02
9 - Root Identifier ........ 32768/00:30:84:00:00:02
A - Root Path Cost ......... 0
C - CIST Menu
M - MSTI Menu
V - VLAN-MSTI Association Menu
P - MSTP Port Parameters
R - Return to Previous Menu
Enter your selection?